This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
Beamicon2 Support Forum › Deutschsprachiges Forum für die Beamicon2 › offenes Forum v
JMC Servo laufen drehen nicht

Linear Mode
JMC Servo laufen drehen nicht
BastlerBerlin Offline
Junior Member
**
Posts: 6
Threads: 2
Joined: Aug 2025
#2
10-21-2025, 01:56 PM
Hallo,

Ich bin weiterhin nicht weitergekommen, Am Servo habe ich kein Rechtecksignal auf dem Ozziloskop messen können. Kann mir evt jemand mitteilen, wie das Impulssignal am LPT Stecker Pin 3 ( x Achse ) aussehen sollte.
bin für jeden Tipp dankbar. Besten Dank im Voraus.

Wieland
Find
Reply


Messages In This Thread
JMC Servo laufen drehen nicht - by BastlerBerlin - 09-26-2025, 05:00 PM
RE: JMC Servo laufen drehen nicht - by BastlerBerlin - 10-21-2025, 01:56 PM
RE: JMC Servo laufen drehen nicht - by NBenezan - 10-23-2025, 08:57 AM
RE: JMC Servo laufen drehen nicht - by NBenezan - 10-24-2025, 08:06 AM

Forum Jump: