This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
Beamicon2 Support Forum › Deutschsprachiges Forum für die Beamicon2 › offenes Forum v
Welche Hardware

Linear Mode
Welche Hardware
Admin Offline
Administrator
*******
Posts: 200
Threads: 21
Joined: Apr 2020
#4
02-09-2026, 03:39 PM
Mit dem Micropod musst Du die Beamicon2Basic Software nutzen. Wenn Du alle Funktionen willst, musst Du da eine Version kaufen.
Beim CNCPod ist die Version inclusive und Du musst die Beamicon2 Software benutzen.

Beim CNCPod kann man eine Erweiterung anstecken, um einen 2. LPT-Port zu haben. Also mehr Eingänge/Ausgänge, weitere Achsen.
Find
Reply


Messages In This Thread
Welche Hardware - by Torsten2245 - 02-06-2026, 04:50 PM
RE: Welche Hardware - by Admin - 02-06-2026, 09:56 PM
RE: Welche Hardware - by Torsten2245 - 02-06-2026, 10:42 PM
RE: Welche Hardware - by Admin - 02-09-2026, 03:39 PM
RE: Welche Hardware - by Torsten2245 - 02-09-2026, 06:32 PM

Forum Jump: