This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Referenz Endschalter Problem
#1
Hallo Admin´s

Ich bin umgestiegen mit meiner 4-Achsmaschine -Servo´s und A-Achse mit Schrittmotor.
Ich habe Bene´s Breakoutbort mit CNCPOD dranhängen.
Die Ein-Ausgänge habe ich mit der Standarteinstellung übernehmen hab nur die Jumper konfig abgeändert.
Die Maschien fährt soweit. Nur stehe ich völlig daneben wie ich die Ref-und Endschalter konfiguriere. ( jeweils ein Schalter am Anfag und Ende der Achse und mit als Ref.Schalter
auf einen Eingang zb.X auf pin 13)
Sie werden erkannt aber bei Ref. dauern als an und bei den Endschalter richtig schaltend ( Die Achse bleibt aber nicht stehen wenn man drauffährt)
Wenn ich das Signal invertiere ist es anders rum (Endschalter leutet und Maschiine läßt sich nicht mehr verfahren)

ich hoffe ich hab das eingermaßen erklärt!
Für eine Hilfe wäre ich dankbar.

Servus Pit
Reply


Messages In This Thread
Referenz Endschalter Problem - by Powerpit - Yesterday, 07:31 PM

Forum Jump: