This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
Beamicon2 Support Forum › Deutschsprachiges Forum für die Beamicon2 › offenes Forum v
Wie Nullpunkt drehen ?

Linear Mode
Wie Nullpunkt drehen ?
beamicom Offline
Junior Member
**
Posts: 1
Threads: 0
Joined: Jan 2022
#8
01-07-2022, 07:59 PM
(04-10-2021, 05:30 PM)technik-fan-ol Wrote: Konfiguration Maschine / / Macros bei "Werkzeuglängentaster tiefste Z-Position  stand auf 0 !!

Habe für meine Hobbyline jetzt den Wert -138 eingestellt und jetzt fährt die Achse in die richtige Richtung.

Leider stimmt der Nullpunkt um ca 3 mm nicht :-(
Dann musst du die Höhe des Tasters #953 in Konfiguration/Maschine/Macros anpassen. Bei mir waren es 2,5 mm
Find
Reply


Messages In This Thread
Wie Nullpunkt drehen ? - by technik-fan-ol - 03-29-2021, 06:20 PM
RE: Wie Nullpunkt drehen ? - by Admin - 03-30-2021, 05:25 PM
RE: Wie Nullpunkt drehen ? - by technik-fan-ol - 03-31-2021, 05:07 PM
RE: Wie Nullpunkt drehen ? - by Admin - 04-01-2021, 09:26 AM
RE: Wie Nullpunkt drehen ? - by technik-fan-ol - 04-02-2021, 08:20 AM
RE: Wie Nullpunkt drehen ? - by Admin - 04-02-2021, 01:38 PM
RE: Wie Nullpunkt drehen ? - by technik-fan-ol - 04-10-2021, 05:30 PM
RE: Wie Nullpunkt drehen ? - by beamicom - 01-07-2022, 07:59 PM

Forum Jump: