This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Leiterplatten Isolationsfräsen: Z Profil scannen - geht das?
#21
G28 ist ja Fahrt zur Parkposition.
G91 ist relativer Modus. Der hat nirgends etwas verloren, es sei denn, man programmiert Unterprogramme relativ.
auch G17 ist überflüssig, da die Beamicon das selbst erkennt.
G94 brauchts auch nicht.

Also, der PP ist irgendwie sehr "oldschool" und hat viele Dinge drin, die es nicht wirklich braucht.
Oder die sogar falsch sind.
Reply


Messages In This Thread
RE: Leiterplatten Isolationsfräsen: Z Profil scannen - geht das? - by Admin - 07-31-2025, 08:55 PM

Forum Jump: